Commission2018-07-06T09:39:48+00:00

Commission

APS offer a full commissioning service including full field wiring, the design and writing of all
software on and off site. The software generally falls into the following categories:

  • PLC software
  • Drive and motion control software
  • Screen visualisation software

Whatever the application APS can provide the expertise to write all the software required for the
machine.

OUR COMMISSION PROCESS

If APS are involved in the commissioning process then this phase happens after the design, build and
installation is complete. Also any safety concerns can be discussed at this point. This will involve a
safety hazard analysis of the commissioning process to ensure minimal risk to personnel and
hardware.

The first part of the process is to test the functionality of the hardware. This may involve testing thedrives can move into position or can run at a particular speed. This is performed with the mechanics uncoupled until complete control over the system is established.

Once the functionality is checked APS will work with the customer to make the machine perform at
the required level. This combines the customers expertise with the expertise and experience of the
APS engineer.

Once commissioning is finished then the machine is fully tested both functionally and from a safety
perspective. Any non-conformities are normally detected here and the machine can be passed fit to beput into production or delivered to the customer.

BUILD CASE STUDIES

August 2018

April 2018

Featured Solutions

LETS WORK TOGETHER

     CALL: 01744 733769

Get in Touch

FIND YOUR SOLUTION

About APS & Lenze


Go to Top